16
REPLACEABLE HANDLE
Your Browning/ProSteel safe is provided with a removable handle (except
Bronze, Bridger and Compact Series safes). This allows you to install a
different style handle or replace an existing one. This can be done easily at
home. Just follow the simple instructions on the handle package. All
needed tools are included.
SHEAR PIN
The handle shaft of your safe is attached to the locking mechanism with a
shear pin. The shear pin will snap if excessive force is applied to your safe
handle (approximately 100 ft/lb.). This feature provides additional security
against attempted break in. If the shear pin is broken, the handle will spin
within the safe door and you will not be able to open your safe. Contact
Browning/ProSteel’s Warranty Service toll free at 877-501-7233 for
assistance with replacement of the handle shear pin.
SHELF ADJUSTMENT
Prior to adjusting any shelf, first remove all items from that shelf. Your
she
lves are held in place by several clips that secure them to four “tracks”
on the safe interior. Some are above the shelves and some are below. To
remove a clip, squeeze it together with hand pressure or pliers and lift up.
The shelves can be relocated along this track by simply relocating the clips
to the desired shelf location. To replace a clip, insert the top lip of the clip
into the appropriate slot in the track, squeeze the clip together and insert
the bottom lip of the clip into the track. It is important that all clips
supporting a particular shelf are located at the same height to ensure that
the shelf sits level.
IMPORTANT: THE GUN RACK IS FRAGILE AND CAN EASILY BE BROKEN
WHEN ATTEMPTING TO REMOVE IT OR INSTALL IT IN A NEW LOCATION.
DO NOT ATTEMPT TO REMOVE THE GUN RACK BY FORCING IT OUT OF THE
RETAINER CLIPS. REMOVE ALL TOP CLIPS BEFORE ATTEMPTING TO MOVE
THE GUN RACK. SUPPORT THE ENTIRE WIDTH OF THE GUN RACK BEFORE
REMOVING IT.
05-142-BSF_Safe OM 10/12/05 4:13 PM Page 16
To Next Page
Loading...