2
Browning/ProSteel fire safes offer similar protection against fire. They are
fire-r esistant, not fireproof. DO NOT ASSUME A FIRE-RESISTANT SAFE
WILL WITHSTAND ANY AND ALL FIRES — IT WILL NOT.
Browning/ProSteel fire-resistant safes are certified in a controlled test
environment that the safe’s interior temperature did not exceed 350° for
the amount of time and temperature exposure as stated on the door label
pla
ced on each safe. Different models of Browning/ProSteel safes have
different fire ratings, and a longer time or higher temperature rating
indicates more fire resistance compared to a safe with a lower rating. You
can improve your fire-resistant safe’s ability to protect your valuables from
fire by placing it in an appropriate location in your home. Follow the
instructions under “Placement of Your Safe” on page 3. A safe is just one
part of protecting your valuables. Adequate homeowner’s insurance
coverage should also be maintained.
INSPECT YOUR SAFE
— Upon receipt of your safe, you should immediately
inspect it for any damage that may have occurred during shipping. If you
detect any damage, call the shipping company that delivered your safe.
IMPORTANT: ANY DAMAGE, CONCEALED OR OTHERWISE, NOT NOTED ON
THE DELIVERY RECEIPT MUST BE REPORTED TO THE SHIPPING COMPANY
WITHIN 15 DAYS OF DELIVERY.
WARNING: THE SAFE DOOR IS HEAVY. DO NOT OPEN THE SAFE WHILE
LOCATED ON AN UNEVEN OR UNSTABLE FLOOR OR ON PLUSH CARPET. THE
WEIGHT OF THE OPEN DOOR COULD CAUSE THE SAFE TO TIP FORWARD.
SEE INSTRUCTIONS ON PAGE 6 FOR ANCHORING YOUR SAFE. FAILURE TO
FOLLOW THESE INSTRUCTIONS OR HEED THIS WARNING COULD RESULT IN
SERIOUS BODILY INJURY OR EVEN DEATH TO YOURSELF OR OTHERS.
UL TOOL ATTACK LISTING
— Browning/ProSteel safes carry the UL tool
attack label certifying the design and construction have been tested by
Underwriters Laboratories and passed the Residential Security Container
test specifications.
OMEGA POINT LISTING AND LABEL
— Browning/ProSteel fire safes carry
the Omega Point Laboratories label and have their design and construction
subjected to a rigorous fire test. Sample safes are placed in a gas furnace
and heated for the amount of time stated to the peak temperature in the
05-142-BSF_Safe OM 10/12/05 4:13 PM Page 2
To Next Page
Loading...