The Silver shotgun is delivered
with the magazine three-shot
adapter (plug) installed in the
magazine, limiting magazine
capacity to two shells in
compliance with federal migratory
bird regulations. If you do not
wish to be limited to three shots,
when it is not required by law, you
can remove (or reinstall) the
three-shot adapter as follows:
R E M O V I N G T H E T H R E E - S H O T
A D A P T O R ( P L U G )
1 Unscrew the magazine cap and
remove it, the forearm, barrel
and gas piston.
2 The magazine three-shot
adapter is located underneath
the magazine spring retainer
located in the forward end of
the magazine tube. To remove
the magazine spring retainer,
depress the magazine spring
retainer tab, located in the
window on the magazine tube
while keeping your hand on
the magazine spring retainer
(Figure 8). Slowly remove the
magazine spring retainer as it
is under pressure from the
magazine spring (Figure 9).
Remove the magazine three-
shot adapter (Figure 10).
We can assume no responsibility for incidents which occur through
the use of shells of nonstandard dimension or those developing
pressures in excess of SAAMI (Sporting Arms and Ammunition
Manufacturer’s Institute) established standards.
Silver 20 gauge, 2¾" chamber models will shoot all 20 gauge
7
/8 oz.
factory lead and steel loads. Silver 20 gauge, 3" chamber models will
shoot all 20 gauge
7
/8 oz. factory lead and steel 2¾" and 3" field loads.
Silver 12 gauge, 3" chamber models will shoot all 1 oz. and heavier
factory lead and steel 12 gauge 2¾" and 3" field loads. Silver 3½"
chamber models will shoot all 1
1
/8 oz. and heavier factory lead and
steel 12 gauge 2¾", 3" and 3½" field loads.
M A G A Z I N E C A P A C I T Y
With the magazine three-shot adapter (plug) removed, Silver 2¾"
shotguns will hold four 2¾" shells in the magazine. Silver 3"
shotguns will hold four 2¾" or three 3" shells in the magazine.
Silver 3½" shotguns will hold four 2¾" shells, or three 3" or 3½"
shells in the magazine.
T H R E E - S H O T A D A P T E R ( P L U G )
AlwAys keep the muZZle pointed in A sAfe direction. before
removing or instAlling the three-shot AdAptor, completely
unloAd the shotgun. open the Action And visuAlly inspect
the chAmber, feed mechAnism And mAgAZine to be Absolutely
certAin the fireArm is completely unloAded. plAce the “sAfety”
in the on sAfe position. fAilure to follow this wArning could
result in serious injury or deAth.
weAr eye protection when removing or instAlling the
three-shot AdAptor to prevent springs, spring-loAded
pArts, solvents or other Agents from contActing your
eyes, resulting in injury.
figure 9
Remove the magazine spring and plug.
figure 10
Remove the plug from the end of the
magazine spring.
figure 8
Depress the magazine spring retainer tab and
ease out the retainer.
To Next Page
Loading...