117
FUEL SYSTEM
FUEL PUMP
6
FUEL PUMP
Removal
Remove the STBD side cover. Refer to side cover
Removal and Installation on p. 177.
Remove the fuel filter from filter bracket.
Disconnect inlet hose and outlet hose from fuel
pump. Remove two screws.
Remove the fuel pump and o-ring. Note position
of pump rod.
IMPORTANT: Do not re-use o-ring.
Inspection
The fuel pump assembly is not serviceable. Do
not disassemble the pump. Inspect fuel pump for
leaks, cracks, or damage.
Installation
Installation is reverse order of removal with spe-
cial attention to the following steps:
IMPORTANT: Before installing fuel pump, rotate
the crankshaft to bring the No. 1 (top cylinder) pis-
ton to Top Dead Center on a compression stroke.
Tighten fuel pump bolts 88 in. lbs. (10 N·m).
1. Fuel filter 005609
1. Inlet hose
2. Outlet hose
3. Screws
4. Fuel pump
005610
2
1
3
4
1. O-ring
2. Pump rod
005611
005612
WARNING
After servicing the fuel system, check for
leaks. Failure to check for fuel leakage
could allow a leak to go undetected,
resulting in fire or explosion.
2
1
To Next Page
Loading...
