133
POWERHEAD
REMOVAL AND INSTALLATION
7
Installation
Installation is reverse order of removal with spe-
cial attention to the following:
Install oil strainer and secure with clamp.
Install dowel pins and gasket on oil pan.
Install dowel pins in front panel.
Coat the driveshaft splines with Moly Lube. Do not
apply lubricant to end of driveshaft.
Lower the powerhead on to oil pan. If necessary,
rotate crankshaft to align crankshaft and drive-
shaft splines.
Apply Gasket Sealing Compound to mounting
screws. Install and tighten 12 screws and two nuts
as follows:
• 8 mm, 16.5 ft. lb. (23 N·m)
• 10 mm, 36 ft. lb. (50 N·m)
1. Oil strainer
2. Clamp
005650
1. Dowel pins
2. Gasket
005651
1. Dowel pins 005652
12
1
2
1
1
005653
005646
005647
To Next Page
Loading...
