BRP Johnson J25R4SUR - Driveshaft Housing and Oil Pan; Removal; Side Cover; Removal and Installation

177
MIDSECTION
SIDE COVER
8
SIDE COVER
Removal and Installation
Pull out rear hook lever.
Remove five screws from starboard side cover.
Disconnect water hose and remove stbd cover.
Remove two screws and port side cover.
Installation is reverse order of removal.
DRIVESHAFT HOUSING
AND OIL PAN
Removal
Remove the powerhead. Refer to Powerhead
Removal on p. 130.
Remove the gearcase. Refer to Gearcase
REMOVAL AND INSTALLATION on p. 200.
Remove E-clip and pull clutch rod out from clutch
arm.
Remove the clutch rod, then slide front panel
away from oil pan.
Remove screw and bonding wire from driveshaft
housing.
005772
1. Water hose 005773
005774
1
1. E-clip
2. Clutch rod
3. Clutch arm
4. Front panel
005775
00005776