194
MIDSECTION
STEERING HANDLE
Installation
Installation is reverse order of removal with spe-
cial attention to the following:
Apply Nut Lock to threads of handle bracket
screws. Install handle and tighten screws 36 ft.
lbs. (50 N·m).
Install bushing, washer, wave washer, shim, and
spacer on tiller handle.
Apply Nut Lock to threads of handle cover screws.
Install handle cover and tighten screws 198 in. lbs.
(23 N·m).
Install and adjust throttle cables. Refer to OUT-
BOARD RIGGING on p. 36.
Check wire and cable routing. Refer to
WIRE/HOSE ROUTING on p. 225.
005794
1. Bushing
2. Washer
3. Wave washer
4. Shim
5. Spacer
005795
005796
To Next Page
Loading...
