210
GEARCASE
ASSEMBLY
Pinion Gear and Driveshaft
Apply gear oil to the pinion gear and install in
gearcase.
Install driveshaft collar with tongue of collar
located in groove on the gearcase.
Install pinion shim, then lower driveshaft assembly
down into the gearcase and through the pinion
gear.
Apply Nut Lock to threads of pinion nut. Install nut
on driveshaft and tighten to 13 ft. lbs. (18 N·m).
Driveshaft Oil Seal Housing
IMPORTANT: Check and adjust shimming
before installing seals in housing. Refer to SHIM-
MING ADJUSTMENTS on p. 214.
When shimming is correct, remove seal housing
for final installation of seals.
Apply DPL to the outer casing of two driveshaft
housing oil seals.
Use seal installer to press seals (one at a time)
into the housing.
005921
1. Tongue 005922
1. Shim 005923
004403
005869
To Next Page
Loading...
