BRP Johnson J25R4SUR - SHIMMING ADJUSTMENTS

212
GEARCASE
ASSEMBLY
Propeller Shaft
IMPORTANT: Before installing propeller shaft
parts, check driveshaft thrust play. Refer to SHIM-
MING ADJUSTMENTS on p. 214.
Install the clutch dog shifter with “F” mark toward
forward gear.
Insert the return spring, push pin, and push rod
into propeller shaft. Depress the push rod and
slide the dog pin into both clutch dog and push
pin.
Install clutch dog spring, ensuring that it fits snugly
into groove on shifter.
Propeller Shaft Bearing Housing
IMPORTANT: Check and adjust shimming
before installing seals and o-rings in bearing
housing. Refer to SHIMMING ADJUSTMENTS on
p. 214.
Propeller Shaft Bearing
Apply HPF XR gearcase lubricant to the bearing.
Using Bearing Installation Tool, P/N 5034774, with
lettered side of bearing facing tool, carefully press
bearing into housing. Bearing is properly installed
when tool flange seats against housing.
Reverse Gear Bearing
Apply HPF XR gearcase lubricant to the bearings.
005928
1. Return spring
2. Push pin
3. Push rod
4. Dog pin
5. Spring
005929
002513
1. Bearing installation tool, P/N 5034774
2. Propeller shaft bearing housing
3. Propeller shaft bearing
002512
2
3
1