BRP Johnson J25R4SUR - Page 90

88
ELECTRICAL
ELECTRIC STARTER SYSTEM
Assembly
Assembly is reverse order of disassembly with special attention to the following steps.
When installing pinion shift lever, refer to diagram for installation direction.
IMPORTANT: When installing armature, use care to avoid breaking brushes.
7 N
.
m
(0.7 kg-m,
5.1 lb-ft)
5.5 N
.
m
(0.55 kg-m, 4.0 lb-ft)
1. Nut
2. Screw
3. Magnetic switch
4. Gasket
5. Spring
6. Plunger
7. Torsion spring
8. Rubber packing
9. Shift lever
10. Front housing
11. Screw
12. Through bolt
13. Rear cover
14. Thrust washer
15. Brush holder
16. Yoke
17. Armature
18. Center cover plate
19. Internal gear
20. Planetary gear
21. Pinion shaft
22. Pinion
23. E-ring
24. Washer
25. Center bracket
26. Rubber ring
27. Stopper ring
28. Pinion stopper