EasyManua.ls Logo

BRP Lynx E-TEC Series - Page 197

BRP Lynx E-TEC Series
368 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
195
BBAASSIICC PPRROOCCEEDDUURREESS
EEnnggiinnee SSttaarrttiinngg PPrroocceedduurree
PPrroocceedduurree
1. Apply parking brake.
2. Recheck throttle control lever operation.
3. Put your helmet on.
4. Ensure that the tether cord cap is installed on the engine cut-off
switch and that the cord is attached to your clothing eyelet.
5. Ensure that the emergency engine stop switch is in the ON position
(up).
WWAARRNNIINNGG
NNeevveerr ddeepprreessss tthhrroottttllee wwhhiillee ssttaarrttiinngg eennggiinnee..
6. Release parking brake.
NNOOTTEE::
For an initial cold start, do not release parking brake. Perform the
ve-
hicle warm-up
procedure as explained below.
MMaannuuaall SSttaarrtt MMooddeellss
Grab rewind starter handle, pull handle slowly until a resistance is felt,
then hold handle firmly and pull vigorously to start engine.
NNOOTTEE::
The maximum torque that can be transmitted to the engine by the re-
wind starter is 80 Nm (59 lbf-ft). The maximum force that can be ex-
erted on the on the rope is 2 200 N (494.6 lbf).
EElleeccttrriicc SSttaarrtt MMooddeellss
660000 EEFFII EEnnggiinnee
Turn the ignition key clockwise to engage the electric starter and start
the engine. Release the key immediately when engine has started.
EE--TTEECC EEnnggiinnee
Depress the START/RER button to engage the electric starter and
start the engine. Release button immediately when engine has
started.
NNOOTTIICCEE
DDoo nnoott eennggaaggee eelleeccttrriicc ssttaarrtteerr ffoorr mmoorree tthhaann 1100 sseeccoonnddss aatt aa
ttiimmee.. AA rreesstt ppeerriioodd sshhoouulldd bbee oobbsseerrvveedd bbeettwweeeenn tthhee ccrraannkkiinngg
ccyycclleess ttoo aallllooww eelleeccttrriicc ssttaarrtteerr ttoo ccooooll ddoowwnn..