EasyManua.ls Logo

BRP Lynx E-TEC Series - Page 200

BRP Lynx E-TEC Series
368 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
198
Start engine as per usual manual starting.
WWAARRNNIINNGG
WWhheenn ssttaarrttiinngg tthhee ssnnoowwmmoobbiillee iinn aann eemmeerrggeennccyy ssiittuuaattiioonn,, uussiinngg
ddrriivvee ppuulllleeyy,, ddoo nnoott rreeiinnssttaallll tthhee bbeelltt gguuaarrdd aanndd rreettuurrnn sslloowwllyy ttoo
hhaavvee ssnnoowwmmoobbiillee rreeppaaiirreedd..
VVeehhiiccllee WWaarrmm--UUpp
Before every ride, vehicle has to be warmed up as follows.
1. Start engine as explained in
Engine Starting Procedure
above.
2. Allow engine to warm up one or two minutes at idle speed.
NNOOTTEE::
Engine will shut down after approximately 12 minutes of idling.
3. Disengage parking brake.
4. Apply throttle until drive pulley engages. Drive at low speed the first
two or three minutes.
BASIC PROCEDURES