EasyManua.ls Logo

BRP Lynx E-TEC Series - Page 228

BRP Lynx E-TEC Series
368 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
226
1. Coolant reservoir
2. COLD line
RReeccoommmmeennddeedd EEnnggiinnee CCoooollaanntt
RREECCOOMMMMEENNDDEEDD CCOOOOLLAANNTT
XPS Extended life pre-mixed coolant
IF THE RECOMMENDED XPS COOLANT IS NOT
AVAILABLE
Distilled water and antifreeze solution (50% distilled water, 50%
antifreeze)
NNOOTTIICCEE
AAllwwaayyss uussee eetthhyylleennee--ggllyyccooll aannttiiffrreeeezzee ccoonnttaaiinniinngg ccoorrrroossiioonn iinn--
hhiibbiittoorrss ssppeecciiffiiccaallllyy ffoorr iinntteerrnnaall ccoommbbuussttiioonn aalluummiinnuumm eennggiinneess..
EExxhhaauusstt SSyysstteemm
EExxhhaauusstt SSyysstteemm VVeerriiffiiccaattiioonn
The muffler tail pipe should be centered with the exit hole in the bottom
pan. Exhaust system must be free of rust or leaks. Make sure that all
parts are securely in place.
Check retaining springs and heat shields condition and replace if
necessary.
MAINTENANCE PROCEDURES