243
TTYYPPIICCAALL
1. Clamping bolt
6. Install drive belt guard.
7. Install side panel.
NNOOTTEE::
These settings are correct as a preliminary adjustment for most mod-
els. In some cases, when starting the engine, the vehicle could creep,
indicating that the drive belt is too tight.
If the vehicle creeps, lower the drive belt height from the prelimi-
nary setting. Repeat procedure until creeping stops.
RReevveerrssee AAccttiivvaattiioonn
NNOOTTEE::
The reverse may not activate if the belt is positioned too high in the
driven pulley. If reverse activation does not work properly, ensure the
drive belt is properly adjusted. Adjust the drive belt lower in the driven
pulley if needed.
MAINTENANCE PROCEDURES
To Next Page