ROT
AX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Pag
e 20/58
Edi
tion 09/2016
10. Eng
ine attachment to chassis
10.1. Attachment via engine pedestal
When using an engine pedestal for the ROTAX engine 125 MAX evo/Junior MAX evo Mini MAX
evo/Micro MAX evo, the engine is inclined at 0° to 15° in the driving direction.
Æ Drill 4 holes (8.5 mm dia / 0.315 in. = drill size) on the coordinates 80 mm x 102 mm
/ 3.15 in. x 4.016 in. in the top plate of the pedestal suitable for the chassis.
p Warning: When drilling the holes in the pedestal, pay attention to the advice of the
chassis manufacturer.
Æ Connect pedestal with engine crankcase with 4 screws M8 (min. strength grade
8.8). Tighten screws to 24 Nm / 212 in. lb.
¿ Note: Thread length in crankcase to be between 16 / 5/8 “- 24 mm / 1 in.
p Warning: Pay attention to chain alignment as advised by chassis manufacturer.
¿ Note: Do not fasten engine on chassis until chain is in position and properly aligned and
tensioned.
To Next Page
Loading...
