BRP Rotax 125 MAX evo - Battery and ECU Installation; ECU Installation into Battery Holder

ROT
AX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Pag
e 24/58
Edi
tion 09/2016
12. Ins
tallation of the battery and ECU
12.1. Install ECU into the battery holder
Æ Prepare two rubber pads (pos. 1) and the control unit (pos. 2) for installation.
Fig. 30
Æ Install the control unit into the respective rubber pad.
TIP: Align at the triangular bottom of the control unit. It fits the rubber pad only in one
position.
Æ Place the upper rubber pad (pos. 1) onto the control unit.
Fig. 31
Æ Insert the complete unit into the battery holder.
¿ Note: If difficulties during insertion occur, the inside of the battery holder can be easily
bent inward so that the distance increases slightly. See Fig. 32.
Also, a bit of silicone spray may ease the installation.