BRP Rotax 125 MAX evo - Battery Installation

ROT
AX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Pag
e 26/58
Edi
tion 09/2016
12.2. In
stallation of the battery
See Fig. 33.
p Warning: Make absolutely sure to avoid short-circuiting of
battery terminals. A short circuit will ruin the
battery and could cause an explosion.
Æ Attach the battery fixture (pos. 5) with the two pipe
clamps (pos. 1– 4) to the left side box beside the
driver’s seat.
¿ Note: The clamps (pos. 2, 3) are designed for chassis
tubes of 30 - 32 mm (1.18 – 1.26 in) dia.
¢ Attention: Risk of clamp fracture! Do not overtighten the screw
(pos. 1) of the pipe clamps (pos. 2, 3).
Æ Install rubber pad (pos. 6) with battery (pos. 7) into
the battery holder (pos. 5).
TIP: The battery fixture (pos. 5) can be fixed with one
screw to one side of the clamp (pos. 3).
See Fig. 34.
Fig. 34
Fig.
33