BRP Rotax 125 MAX evo - Engine Start and Operation; Pre-Start Checklist; Cold Engine Start Procedure; Engine Start Failure Troubleshooting

Ope
rator’s Manual ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Pag
e 50/58
Edi
tion 09/2016
7. Engine
start and operation
7.1. Engine start
Prior to engine start, verify the following:
P Fuel
tank full.
P Battery charged and connected.
P Battery voltage over 12 V.
P Carburetor Bowden cable is moving freely and carburetor piston connected in idle
position.
At engine start proceed as follows:
Æ On a
cold engine, pull the choke lever (pos. 1, Fig. 5) into a vertical position.
Fig. 5
Æ Press the power button once, the electric starter is activated (light turns on). Press
the button again until the engine starts (Fig. 6).
¿ Note: If the engine does not start, repeat the operation after a few seconds in the same
manner.
Æ After engine start, take choke back slowly until engine idles smoothly without choke.
Fig. 6