BRP Rotax 125 MAX evo - Exhaust Valve Timing Variants; Variant 1, Position B Connection; Variant 2: Starter Relay Connection; Installed Variant Note

Ope
rator’s Manual ROTAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Pag
e 53/58
Edi
tion 09/2016
B:
See Fig. 8.
The additional cable is attached to the ground wire. The control of the exhaust valve timing is
activated
at 7600 rpm.
Fig. 8
Variant 2: Additional cable at starter relay
A:
See Fig. 9.
The additional cable is NOT attached to the ground wire. The control of the exhaust valve timing is
activated at 7900 rpm.
¿ Note: Isolate the additional cable with an electrical/insulating tape to the ground wire so
that a possible contact with the engine ground does not affect the function.
B:
See Fig. 9
The additional cable is attached to the ground wire. The control of the exhaust valve timing is
activated
at 7600 rpm.