BRP Rotax 125 MAX evo - Fuel System Installation; Fuel Pump Installation and Connection

RO
TAX 125 MAX evo, Junior MAX evo, Mini MAX evo, Micro MAX evo
Pa
ge 7/58
Ed
ition 09/2016
2. In
stallation and connection of the fuel system
2.1. Installation and connection of the fuel pump
Æ The retaining plate, rubber buffers, fuel pump, fuel hose (with 230 mm and
1800 mm length) are already pre-assembled. See Fig. 1.
Fig. 1
Æ Install the support bracket (pos. 1) with fuel pump on the carburetor socket using 3
screws M6x30 (pos. 2). Tightening torque 6 Nm / 53 lbf in. See Fig. 2.
Fig. 2
Æ The fuel hose with 230 mm length will be connected later to the carburetor, see
carburetor installation in section 3.
Æ The larger fuel hose (pos. 1) should be connected to the fuel filter (pos. 2) and
furthermore to the fuel tank. See Fig. 3.
Fig. 3
TIP: Facilitate the assembly of fuel hose by slightly widening the hose end with a pair of
circlip pliers.