BRP ROTAX 912 Series - Page 129

BRP-Rotax
MAINTENANCE MANUAL LINE
Step
Procedure
1
Lightly tap and brush off surface dirt (A).
2
Spray K&N filter cleaner onto filter surface and leave to soak for approx. 10
min. (B).
3 Rinse air filter with low pressure water from inside to outside and let ele-
ment dry naturally (C).
08864
A B C
Figure 7.8: Cleaning the dry air filter
After cleaning
ATTENTION
Never use gear oil, diesel or engine oil, as they attract humidity. Overoiling of the
air filter reduces airflow causing rich mixture.
NOTE
Each filter pleat must be sprayed with oil.
After 5 to 10 min. the filter will be soaked with oil, noticeable by the uniform red coloring.
08865
A
I
R
F
I
L
T
E
R
O
I
L
Figure 7.9: After cleaning
Effectivity: 912 Series
Rev. 0
12–20–00
Page 17
January 01 2020