BRP ROTAX 912 Series - Page 140

BRP-Rotax
MAINTENANCE MANUAL LINE
NOTE
Perform a mechanical synchronization before attempting a pneumatic
synchronization.
Special tool The two carburetors are adjusted to equal flow rate at idling with a suitable flow meter or
vacuum gauge(s).
Connection Possible connection methods.
Option 1
Step
Procedure
1
Remove the compensating tube (2) from the push on angular tube (4) after
removing the two clamps.
2
Using the push on angular tube (4) and compensating tube (2) install a flexi-
ble rubber hose (5) leading to the vacuum gauge (1).
AE_912_0085
2
4
3
5
1
4
3
5
Figure 7.17: Option 1
1
Vacuum gauge
2
Compensating tube
3
Clamp
4
Angular tube
5 Rubber hose
12–20–00
Page 28
January 01 2020
Effectivity: 912 Series
Rev. 0