BRP-Rotax
MAINTENANCE MANUAL LINE
ATTENTION
To ensure correct functioning of the oil circuit and the forced flow lubrication,
use ORIGINAL ROTAX® oil filter only. Only these filters will ensure correct pres-
sure in the by-pass valve.
At every oil change, unscrew the oil filter and cut open using special tool taking care not to
produce chips.
Special tools To carry out the procedure the following tools are necessary:
part number Description
part no. 877620* (1) Oil filter wrench
part no. 877670* (2) Cutting tool
* or equivalent
Figure 7.26: Special tool
1
Oil filter wrench part no. 877620*
2
Cutting tool part no. 877670
*or equivalent
Procedure To remove the oil filter the following steps are necessary:
12–20–00
Page 44
January 01 2020
Effectivity: 912 Series
Rev. 0
To Next Page
Loading...
