BRP ROTAX 916 i A Series - Engine Preservation Procedures; General Environmental Corrosion

BRP-Rotax
INSTALLATION MANUAL
Centre of gravity
of engine
Center of gravity (COG) position information only considers the engine itself. Parts without
a specific installation position relative to the reference coordinate system are not
considered.
NOTE
All distances are given in relation to the reference coordinate system (P).
NOTE
The COG will slightly change when adjusting the orientation of the resonator.
Axis
Center of gravity
X-axis
- 377 mm (-14.84 in.)
Y-axis
- 9.4 mm (-0.35 in.)
Z-axis
- 115 mm (-4.52 in.)
Moments of iner-
tia (relative to
COG)
NOTE
The MOI will slightly change when adjusting the orientation of the resonator.
Axis Moment of intertia
X-axis
2467496 kg*mm
2
Y-axis
2600923 kg*mm
2
Z-axis
2752637 kg*mm
2
Dimensions
NOTE
The Overall length and height may vary by adjusting the orientation of the
resonator.
Description
Dimension
Overall length (w/o intercooler and hoses) 657 mm (25.87 in.)
Overall length with suspension frame 657 mm (25.87 in.)
Overall height (w/o exhaust system and sus-
pension frame)
398 mm (15.67 in.)
Overall height with exhaust system 673 mm (26.50 in.)
Overall height with engine suspension frame 430 mm (16.93 in.)
Overall width (w/o exhaust end pipe, intercooler
and hoses)
578 mm (22.76 in.)
72–00–00
Page 12
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1