180
IInnssttaalllliinngg tthhee UUppppeerr BBooddyy MMoodduullee
1. At front, insert the upper body module tabs into the bottom pan
openings.
FFRROONNTT HHOOOODD TTAABB
2. Lower the rear end of the upper body module.
3. Insert the rear end hooks of the upper body module into the slots in
the console.
NNOOTTEE::
Make sure the air intake duct is positioned properly connected.
4. Tighten air intake duct clamp.
TTIIGGHHTTEENNIINNGG TTOORRQQUUEE
Intake duct clamp 1.0 ± 0.2 Nm (9 ± 2 lbf-in)
5. On both sides, install the upper body module retaining screws.
TTIIGGHHTTEENNIINNGG TTOORRQQUUEE
Upper body screws 1.8 ± 0.2 Nm (16 ± 2 lbf-in)
6. Connect the manifold air pressure and temperature sensor
(MAPTS) connector (2-stroke engine).
7. Connect the headlight connectors.
8. Install the storage compartment but leave the cover open.
BODY AND SEAT
To Next Page