Drive pulley bolt recommended torque:
115 -125 Nm ( 85-92 lbf
•
ft )
Not applying the recommended torque may result in a
major failure of the drive pulley and the engine. Refer to
the shop manual for the complete assembly procedure.
NOTICE
This guard must ALWAYS be in place when the
engine is running. Beware of rotating parts, they could
cause injuries or catch your clothing.
Ce protecteur doit TOUJOURS être en place lorsque le
moteur tourne, les pièces en rotation peuvent provoquer
des blessures ou prendre dans vos vêtements.
WARNING / AVERTISSEMENT
10898
To Next Page
Loading...
