30
To
access the data stored in the Analyzer Memory the
operator
selects the "Replay/Plot"
pushkey. This produces a DISPLAY
OR
PLOT?
message on the Analyzer Display.
At
the same time the LEOs on the "Display" and "Replay/Plot" pushkeys flash alternately. If
the data is
to
be replayed on the Display, the "Display" pushkey should be activated (see
Fig. 3.9).
To
access the data via the Rear Panel outputs the "Replay/Plot" pushkey
should be activated (see Fig.
3.10 and also Chapter
5).
To Next Page
Loading...
