15
If you the enter AT\S you should get this status screen:
Now you can switch off the M1, position it on the remote site and
connect it to the SLM with an AO1440 cable (which is a male/female
9-pin/9-pin RS–232 cable).
Table5 Siemens M1 programming
commands
Enter Command Significance
ATS0=1 Answer after 1st ring
AT\N6 Operating mode: Non-Transparent,
with RLP protocol
ATB98 Operating mode: Autobauding
Modem, 9600 Baud
ATQ1 No Result codes
AT&Y0 Load User Profile 0 at power-up
AT&W0 Write the new configuration to non-
volatile memory as User Profile 0
To Next Page
Loading...
