BB106411.book : 2237-ch3 Black 17
Chapter 3 – Taking Measurements
Making Measurement Settings
BB1064–11
3–17
2237 Controller
User Manual
3.4.3 Setting the Measurement Time
The 2237 Controller can be set to measure for a fixed amount
of time. When the set time has elapsed, measurement is
stopped automatically and the results are stored in the next
available record (except when the off (manual) setting is
used).
There are 10 preset time settings available:
● Off (manual) ● 8 min
● 10 s ● 10 min
● 30 s ● 30 min
● 1 min ● 1h
● 5 min ● 8h
If the preset time is set to Off (manual), then the instrument
will continue measuring until you press . Also, results
will not be saved automatically. For instructions on how to
save results from a manually timed measurement, refer to
section 4.1.1.
To begin a measurement, regardless of the preset time set-
ting, simply switch on the instrument by pressing . If the
instrument is already switched on but not measuring, then
press to begin measuring.
To interrupt a preset-timed measurement in progress, press
. Note that the results will not be saved to a record in
this case. For instructions on how to save results from a
manually stopped measurement, refer to section 4.1.1.
To Next Page
Loading...
