BB106411.book : 2237-ch3 Black 19
Chapter 3 – Taking Measurements
Making Measurement Settings
BB1064–11
3–19
2237 Controller
User Manual
3.4.4 Setting the Time and Date
Date and time information is stored with each record you
save. Therefore, it is important to make sure this information
is correct.
To set the date and time:
1. If the instrument is measuring, then press to stop
it. The Measurement Window must read STOP (as shown
below), not RUN.
2. Press until the Date/Time Set-up Window is visible
on the screen, as shown below.
3. A blinking cursor indicates the currently selected param-
eter. In the figure above, the cursor points to the number
“04”, which is the day. To increment the day, press .
To decrement the day, press . Continue to use these
cursors until the correct day is shown.
Fig.3.12 The display when measurement is stopped
Fig.3.13 The Date/Time Set-up Window
STOP 00:05:41
MaxP 94.7 dB
AF Leq 45.8 dB
30 100
SET-UP
Date/Time
>04 Jan 1996
22:15:02
To Next Page
Loading...
