BRUEL & KJAER 2237 - Recalling a Stored Record

BB106411.book : 2237-ch4 Black 5
Chapter 4 – Data Operations
Working with Records
BB1064–11
4–5
2237 Controller
User Manual
4.1.3 Recalling a Stored Record
To view the results of any of your stored measurements, follow
the procedure below.
1. If the instrument is measuring, then press to stop
it. The Measurement Window must read STOP (as shown
below), not RUN.
2. Press until the Recall Records to Display Window is
visible on the screen, as shown below.
3. Press to display the most recently stored record,
which will resemble the example shown in Fig.4.5. Note
that if an overload occurred during the measurement,
then the value for each parameter will blink.
Fig.4.3 The display when measurement is stopped
Fig.4.4 The Recall Records to Display Window
STOP 00:05:41
MaxP 94.7 dB
AF Leq 45.8 dB
30 100
RECALL
Records
to
Display