BRUEL & KJAER 2239 A - When All Records Are Full; Recalling a Stored Record

Chapter 4 – Data Operations
Working with Records
BB 1219 – 11
39
Integrating Sound Level Meter Type 2239 A
User Manual
4.1.2 When All Records are Full
If you attempt to store a record (either manually, or after a
preset interval) after all 40 records have been filled, you will
see the following message:
If you see this message, then you must erase some or all of
your records (see section 4.1.4) or take written records of your
measurements.
To prevent problems:
● Always erase all records after you have downloaded and
saved them to your computer’s hard disk.
● Erase records of invalid measurements (e.g., overloads)
right away by using the Erase Last Record command (see
section 4.1.4).
4.1.3 Recalling a Stored Record
To view the results of any of your stored measurements, follow
the procedure below.
1. If the instrument is measuring, then press to stop it.
The Measurement Window must read
STOP (as shown in
Fig.4.3 ), not
RUN.
2. Press until the Recall Records to Display Window is
visible on the screen (as shown in Fig.4.4 ).
3. Press to display the most recently stored record,
which will resemble the example shown in Fig. 4.5. Note
Fig.4.2 The No Free Records warning
*** WARNING ****
No Free Record
to Store Current
Measurement
bb221911.book Page 39 Tuesday, July 24, 2001 11:23 AM