Chapter 4 – Data Operations
Using a Portable Printer
BB 1219 – 11
45
Integrating Sound Level Meter Type 2239 A
User Manual
3. Connect the other end of the cable to your printer as
described in your printer manual.
4. If necessary, switch on the printer as described in your
printer manual.
5. Configure your printer to use the communication setup
listed below. See your printer manual for instructions.
● 9600 Baud
● 8 data bits
● 1 stop bit
● Parity: none
● Handshake: XON/XOFF
6. If you have not taken a measurement, then take a complete
measurement as described in section 3.2. Make sure meas-
urement has stopped before proceeding.
7. Press until the Print Measurement Window is visible
on the screen, as shown below.
8. Press to begin printing. Press to cancel the op-
eration.
4.2.2 Reading the Printout
Type 2239 A generates a printout that supplies the following
information:
● Time weighting
Fig.4.13 The Print Measurement Window
OUTPUT
Current
Measurement
to Printer
bb221911.book Page 45 Tuesday, July 24, 2001 11:23 AM
To Next Page
Loading...
