Sound Level Meter Types 2245 –
Instruction Manual
Page 20 of 110
Press again to reset the measurement and display, ready for a new
measurement.
2.5.2 Overload and Underrange
????
2.6 Looking at the measurement
There is a number of measurement displays (SLM, List, Spectrum, Profile and About
data), you navigate between them using the up/down arrow buttons :
Note: Use right and left buttons in the measurement displays to toggle the (main)
parameter in the display without going into the Display settings. Press and hold the
buttons down to move the cursor (Spectrum and Profile only).
Press and hold the up button down to zoom the y-axis on the spectrum and the
profile.
The About data display shows the precondition for the measurement.
To Next Page
Loading...
