Chapter 3– Setting Up the Analyzer
Introduction
28
Brüel & KjærModular Precision Sound Analyzer Type 2260
User Manual
3.1 Introduction
This chapter will tell you how to configure your analyzer.
The configuration of the analyzer is set up via two menus:
● system menu: for configuring the analyzer using various
service functions that are independent of the application
software installed (for example, copying/deleting files and
changing application)
● set-up menu: for configuring the analyzer’s output and
measurement set-up (for example, which data are to be
measured). The set-up will depend on the application soft-
ware in question.
For an overview of these menus, see Chapter 9 and the rele-
vant application software’s manual.
3.2 Installing and Changing Applications
3.2.1 Introduction
Modular Precision Sound Analyzer Type2260 must have appli-
cation software installed, together with the appropiate acces-
sories, for it to be able to measure sound and/or vibration.
Modular Precision Sound Analyzer Type2260 can have several
application software packages installed in it at the same time.
You just select the one you need for the particular analysis
task.
3.2.2 How to Find Out Which Applications Are Installed
1. Press the hard key to select the System menu (see
Fig.3.1).
2. Press the <Applications> soft key.
bb095513.book Page 28 Tuesday, April 9, 2002 1:42 PM
To Next Page
Loading...
