Chapter 5– Outputting to Printer or Computer
Setting Up for Transferring to a Computer
BB0955-13
65
Modular Precision Sound Analyzer Type 2260
User Manual
5. With the Printer/Output Set-up menu on the display, for
example Fig.5.3. (see also section 5.2), select
Type and
set it to
Spread Sheet.
6. Select
Handshake and set it to Hardwire.
7. Select
Baud Rate and set it to 9600.
The handshakes and baud rates of the analyzer and the
computer must be the same to enable them to communi-
cate without losing or corrupting data.
8. Repeat step 7 for all the settings you want to change.
9. Press the
<Save> soft key to save the printer/output set-
up.
Alternatively, press the
<Undo> soft key to cancel any
changes to the printer/output set-up and return to the
previously saved printer/output set-up.
10. Press the
<Set-up Menu> soft key to return to the Set-
up Menu.
Fig.5.3 A typical Print/Output Set-up menu for trans-
ferring set-up data to a computer
bb095513.book Page 65 Tuesday, April 9, 2002 1:42 PM
To Next Page
Loading...
