BRUEL & KJAER 2305 - MM to 100 MM; Writing Pens; Sapphire

required). Ensure that the stop is fully in hole H and clipped firmly .
5. Withdraw 100 mm roll and re-load with 50 mm paper as instructed in
Para "Insertion of Recording Paper", item A, "Rolled Paper".
B. 60 mm TO 100 mm.
The above is carried out but reversed;-
1. Detach driving arm from bogie at point H.
2. Move the bogie to the right-hand end of the paper scale and insert
wishbone head of driving arm in single hole drive lug G.
3. Load with 100 mm paper .
Writing Pens
A. SAPPHIRE.
34
The two Sapphire Styles for use on waxed paper are supplied in a loaded
position on the Writing and the Event Marker Penholders respectively
Removing.
The Writing Sapphire Stylus is removed from the Penholder
by pulling gently forwards, see Fig . 3.4a.
Ev ent Marker
Pen Holder
fff ....---- Sapphire Styl us
~-
/
(a)
Pair of
Tweezers
(b)
Fig. 9.4. Removing of Sapphire Styles.
(a) Writing Stylus.
(b) Event Marker Stylus.
IbIS"
The Event Marker Sapphire Stylus is removed by pulling gently to the
right as illustrated in Fig . 3.4b. Make sure when removing that the
sapphire rides free of the Guide Clip E (the Event Marker is lifted
gently) .
A pair of tweezers or pliers make a good aid when removing the
Event Marker Sapphire Stylus.
Replacing.
The Writing Sapphire Stylus is pushed in and o\,er the Pen·
holder .