BRUEL & KJAER 2305 - Specification

on the table panel or on the Level Recorder. After one complete
revolution the equipment will automatically stop.
NOTE: 110 not switch the motor of the Turntable or the Recorder
off during rotation of table, otherwise synchronization will
be lost.
Stop
and start of the equipment during running off one revolution can
be carried out by operating the PAPER DRIVE, STOP START switch
on the Level Recorder .
D. Remote Control.
For remote control starting of the equipment, connections should be made
to the jack REMOTE CONTROL of the Turntable as shown in Fig. 4. 7.
By the opening of the remote contact the equipment will start running
through a complete revolution.
viewed externally
161820
Fig. 4.7. Wiring of jack "Remote Control" on Turntab;e for remote
controlling
of "stop" and "starf'.
Table Plate Diameter:
Load (on Center):*)
Thread for the Six
Mounting Holes on
Table:
Rotation Speed:
Power Supply:-
Voltage:
Frequency:
Consumption:
Wcight:
SPECIFICATION
354 mm
Max. 100 kg
UNF 10-32 or M5.
0.75 r.p.m.
100-115-127-150-220 and 240 V
50 or 60 Hz (cIs) (to be specified when ordering)
25 watt approx.
12 kg (26 Ibs.)
*) The load on the perifery can be 30 kg when the table plate is lined up perfe ctl)
horizontal.
50