Address Switch
Address Switch Coding
-1~,
----0~~
8
1: Reset
0 :
Accumulate
87654321
7
1:
Printer 0 : Calculator
6 1:
Ton
0 : Addressable
5
A5
MSB
4
A4
3
A3
I
O~ioo
2
A2
Address
Al
LSB
Fig. 5.4.
The
ADDRESS SWITCH on the rear panel
of
the 2512
When using the Type 2512 in the addressable mode, subswitches 7 and 6
of
the ADDRESS
SWITCH should be set as follows:
Subswitch 7
Subswitch 6
"0: Calculator". The data is then output in the short-
ened form without the explanatory text, only with a text
code, as shown in Fig.4.1, section
4.1.
"0: Addressable"
The remaining positions from 5 to 1 can be set to the required address, which should be
different from the addresses
of
all other instruments on the interface bus.
31
(2
5
-1)
different
addresses can be formed via these five switches, although the limit
of
the interface bus is only
14
instruments. The address is set to 01100 at the factory.
In
addition, the INTERFACE pushkey on the front panel
of
the 2512 must be active, i.e. its LED
must be on.
47
To Next Page
Loading...
