BRUEL & KJAER 2525 - Page 103

Measuring Ampifier Type 2525
User Manual Vol.2
9–5
BE1394– 11
Chapter 9 – Command Summary
Channel_1 Dependent Commands
Measurement_Mode
Measurement_Mode?
Char. Force
*Acceleration
Displacement
Velocity
6.3.1
Measurement_Status? 5.3.2
Measurement_Status_Enable
Measurement_Status_Enable?
Char.
NR
Auto_Ranging
Common_Mode_Overload
Signal_Overload
Alarm
Deltatron_Error
Upper_20_Db
Detector_Overload
None
All
*0 to 255
5.3.2
Mounted_Impulse_Frequency
Mounted_Impulse_Frequency?
NR 3.0E+03 to 60.0E+03Hz
*( default = 30E+03E)
6.9.1
Mounted_Resonance_Frequency? 6.9.2
Operation_Complete? 5.3.2
Operation_Complete_Enable
Operation_Complete_Enable?
Char.
NR
Measurement_Finished
Settling_Finished
None
All
*0 to 255
5.3.2
Output_Gain
Output_Gain?
NR
*0, 10, 20 6.3.4
Peak_Hold_Time
Peak_Hold_Time?
NR
Char.
0.5 to 60.0s
*(default = 5.0)
Infinite
6.3.9
Reference_Generator
Reference_Generator?
Char. On
*OFf
6.6
Reset_Single Char. Alarm
Channel
Detectors
Measurement_Status
Measurement_Status_Enable
Operation_Complete
Operation_Complete_Enable
5.4.1
Command Header Input Message
Data Type
Options (
*=default)
Section
Table 9.2 (cont.) Command Summary – Channel_1 Dependent Commands