BRUEL & KJAER 2525 - Page 77

Measuring Ampifier Type 2525
User Manual Vol.2
6–19
BE1394– 11
Chapter 6 – Set-up and Display (Results) Messages
Measurement Set-up Commands
6.3.13 Alarm Hold Time
Once the alarm goes off, the current level can be retained for a period of time
specified as shown in Fig.6.30.
If the Hold Time is specified as greater than 60.5 s, then the Hold Time is set to
Infinite. Otherwise the Hold Time is set as follows:
Range: From 0 to 60 s
Resolution: 1 s
Round: Nearest 1 s
Default: 1 s
The syntax for the query is shown in Fig.6.31.
Fig.6.30 The syntax for the command Alarm_Hold_Time
Fig.6.31 The syntax for the query Alarm_Hold_Time? and amplifier response
941115e
Te
CHANNEL_1
INFINITE
To 2525
: SP
S
—
ALARM_HOLD_TIME
:
Hold Time
NR
941105e
Te
CHANNEL_1
CHANNEL_1
To 2525
:
ALARM_HOLD_TIME?
Header OFf
Te
From 2525
: :
Alarm Hold Time
Char/NR
SP
—
ALARM_HOLD_TIME
: