Measuring Ampifier Type 2525
User Manual Vol.2
Brüel & Kjær
6–20
Chapter 6 – Set-up and Display (Results) Messages
Measurement Set-up Commands
6.3.14 Alarm_Level_Exceed_Time
This command allows you to specify the amount of time the level can exceed the
specified alarm level before the alarm will go off. The syntax for the command is
shown in Fig.6.32.
The Time is set as follows:
Range: 0 to 60 s
Resolution: 1 s
Round: Nearest 1 s
Default: 1 s
The syntax for the query is shown in Fig.6.33.
Fig.6.32 The syntax for the command Alarm_Level_Exceed_Time
Fig.6.33 The syntax for the query Alarm_Level_Exceed_Time? and amplifier response
941116e
Te
CHANNEL_1
To 2525
: SP
S
—
ALARM_LEVEL_EXCEED_TIME
:
Time
NR
941106e
Te
CHANNEL_1
CHANNEL_1
To 2525
:
ALARM_LEVEL_EXCEED_TIME?
Header OFf
Te
From 2525
: :
Time
NR
SP
—
ALARM_LEVEL_EXCEED_TIME
:
To Next Page
Loading...
