BRUEL & KJAER 2525 - Page 79

Measuring Ampifier Type 2525
User Manual Vol.2
6–21
BE1394– 11
Chapter 6 – Set-up and Display (Results) Messages
Measurement Set-up Commands
6.3.15 Detector_Dc_Output
The syntax appears as shown in Fig.6.34.
The default selection is Rms. If one of the Char. options is not selected, then the
DC Output Voltage can be specified as follows:
Voltage: 0V or 1V
Round: Nearest
Resolution: As shown
The syntax for the query appears as shown in Fig.6.35.
Fig.6.34 The syntax for the command Detector_Dc_Output command syntax
Fig.6.35 The syntax for the query Detector_Dc_Output? and amplifier response
941119e
Te
CHANNEL_1 DETECTOR_DC_OUTPUT
To 2525
: SP
—
:
RMS
POSITIVE_PEAK
NEGATIVE_PEAK
PEAK_PEAK
Level
NR
V
941109e
Te
CHANNEL_1
CHANNEL_1
DETECTOR_DC_OUTPUT?
To 2525
:
Header OFf
Te
From 2525
: :
Value
Char/NR
SP
—
:
DETECTOR_DC_OUTPUT