Measuring Ampifier Type 2525
User Manual Vol.2
Brüel & Kjær
7–2
Chapter 7 – Measurement Data
Introduction
7.1 Introduction
Measurement Data is output by the amplifier using the query message shown in
Fig.7.1.
Measurement_Data:Current_Data causes the amplifier to return the data as it is
specified in Display_Set_Up (Rms, POsitive_Peak, NEgative_Peak, or Peak_Peak).
That is, from 1 to 3 results can be output.
Measurement_Data:All_Data causes the amplifier to return all four (Rms,
POsitive_Peak, NEgative_Peak, and Peak_Peak).
The Status boxes correspond to Measurement Status Event Register and the Opera-
tion Complete Event Register respectively. See section 5.3.2 .
Note: When autoranging is on, the corresponding measurement results will be “0”.
This can be observed in the Measurement_Status (Status Box 1).
Fig.7.1 The message syntax for the command query pair which reads-out amplifier measurement
data
941168e
To 2525
:
:
ALL_DATA?
CURRENT_DATA?
MEASUREMENT_DATA:
ALL_DATA
MEASUREMENT_DATA:
CURRENT_DATA
MEASUREMENT_DATA
Header OFf
Repeated for each measurement result (see below)
Te
From 2525
:
Meas Value
NR
Status 1
NR1
Status 2
NR1
SP
,
,
—
Te
To Next Page
Loading...
