MATRON-Light with 2250-M Field Guide, Page 34
recommended) or through a set of headphones or amplifier/speaker attached to
the headphones output socket on your computer.
10.8 You can control the replay by the start button (
) and stop button ( ) or use
the spacebar on the computer keyboard. The volume can be increased (
or
use keyboard F7) and decreased (
or use keyboard F8).
10.9 You can listen to a recording starting at any point during that event (not just
from the beginning). To do this identify the recording and zoom to expand the
event as here:
Position your mouse cursor anywhere within the marked recording (as shown by
the vertical red cursor in the diagram above) and press the
button.
If you are using Type 7820 Evaluator then you can move the results to the
“Calculations” section and carry out analysis of the noise results. Here is an example:
Further information is available in the following publications:
a) SV7815-101.1 Type 7815 Noise Explorer UK Practical Tutorial
b) SV2250-103.1 7820 Evaluator UK Practical Tutorial for 2250
To Next Page
Loading...
