BRUEL & KJAER Mediator 2238 - Serial Interface Commands Overview; Frequency_Weighting_2 Serial Command

Chapter 8 – Interface
Controlling Mediator via the Serial Interface
8–2
Brüel & Kjær2238 Mediator
User Manual
8.1 Controlling Mediator via the
Serial Interface
8.1.1 Commands
The command and query messages available with the En-
hanced module are listed in Table 8.1. The interface jobs that
are specific for the enhanced module are explained in the
following.
8.1.2 Frequency_Weighting_2
The Frequency_Weighting_2 command is used for setting up
the frequency weighting options for Detector 2. The syntax is
shown in Fig. 8.1.
The default setting is: Peak and C-weighting
Message Command Query Message Command Query
Bandwidth ••PArameter •
Continue • PAUse •
Error • RAnge ••
File • REset •
Frequency_
Weighting_1
••SEtup ••
Frequency_
Weighting_2
••STatus •
Header ••SYstem ••
IDentify • Version •
Key •
Table 8.1 Command and query message overview