Chapter 8 – Interface
Controlling Mediator via the Serial Interface
BB1122–11
8–7
2238 Mediator
User Manual
8.1.4 SEtup
The SEtup commands are used for setting up most of the
measurement parameters in the Measurement Setting menu.
SEtup Commands
The SEtup commands (except for Auto Start) use the syntax
illustrated in Fig. 8.4.
Fig.8.4 Syntax for the SEtup command
Sub Header Parameter Setting Comments
Aux_1Out
In
Char Sets Aux 1 to AC Output
Sets Aux 1 to DC Input
Aux_1_FW LINear_Frequency_
Weighting
Detector_1_Frequen
cy_Weighting
Char Sets Linear Frequency
weighting or Detector 1 out-
put to the Aux 1 output
Aux_2Out
In
Trigger_In
Trigger_Out
Char Sets Aux 2 to DC Output
Sets Aux 2 to DC Input
Sets Aux 2 to Trigger Input
Sets Aux 2 to Trigger Out-
put
Criterion_Level 70 ... 100 NR3 Sets Criterion level between
70 and 100dB
Exchange_Rate 4, 5 NR1 Sets Exchange Rate to 4 or
5dB
Exposure_Time (Hour) 0 ... 23
(Minute) 0 ... 59
NR1 Sets Exposure Time in
hours and minutes
Table 8.3 Sub-header and parameter settings for the SEtup command
980215e
Te
: :
SETUP
SP
—
Sub Header
See table
See table
Parameter
To Next Page
Loading...
