PULSE Multi-analyzer System Type 3560-B/C/D/E – Installation and IDAe Hardware108
3) Load the CD that came with the system.
4) Change the IP address of the Linksys WET54 to IP: 10.10.10.70.
5) Put a label on the Linksys WET54 with “IP=10.10.10.70”.
6) Disconnect the Linksys WET54.
7) Connect the second Linksys WET54 to the normal LAN interface in the PC.
8) Load the CD that came with the system.
9) Change the IP address of the Linksys WET54 to IP: 10.10.10.75.
10) Put a label on the Linksys WET54 with “IP=10.10.10.75”.
11) Connect the first Linksys WET54 marked IP=10.10.10.70 to the front-end.
12) Run the program Start, Programs, PULSE, PULSE Front-end Setup.
13) Change the PC’s standard LAN IP to 10.10.10.50.
14) Set the IP address of the front-end to 10.10.10.11 (factory default).
15) Run the setup program to the end.
16) You can now run PULSE.
9.5 Further Information
For an overview of a working Wireless LAN solution, please refer to Installation Manual for
PULSE Vehicle Pass-by Solutions (BE 1716), which can be found in PULSE Knowledge
Library (select Product: 7788 PULSE Vehicle Pass-by).
To Next Page
Loading...
