© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 115 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
16.1.10 Adding Measurements or Waveforms to a Channel
Many channel types allow you to add measurements. For example, you may want to measure both
integrated and non-integrated data from an acceleration sensor or add an additional tracking filter to a
Radial Vibration channel.
To add a measurement:
1. Select the Measurement tab (All view).
2. Select Add.
3. Navigate to the monitor channel and select from the available measurements.
If no measurements are shown, then adding measurements is not supported for that channel type, or
all available measurements have already been added.
After adding, the new measurement may appear at the bottom of the measurement list (and be hard
to find). Change the View from All to Primary and then back again. This will sort the list and place all
measurements in their correct locations. If a waveform is added, it will appear in the Waveform view.
Figure 16-5) Add a measurement or waveform
16.1.11 Deleting Measurements or Waveforms from a Channel
To delete a measurement, select the row and then click the Delete button. You cannot delete the
primary measurement or gap/bias measurements.
To delete a waveform, select the row and then click the Delete button. Waveforms cannot be
enabled/disabled by the user; they can only be added or deleted. Synchronous waveforms are
automatically disabled (by the software) if there is no associated phase trigger.
To Next Page
Loading...