© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 117 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
17 Configuring - Relays Tab
17.1 Basic Navigation and Layout
The Relay Logic tab allows you to diagram your logic. The
basic elements are shown below.
Control Description
(1) Add button Add logic blocks as needed
(2) View Select Relay Editor or Summary view.
(3) Monitor Select Monitor. All four relay channels on the
selected monitor will be shown on the screen.
(4) “For Any” Logic Block This logic block is a logical OR of all channels
specified in the group.
(5) Connector Connects Logic to the relay channel
(6) Relay channel Specifies the relay channel (1-4), the relay
channel name, and the Energized, and Latching
settings
Table 17-1) Relay Logic Editor
Figure 17-2) Relay Logic Editor
16-1 Relays tab
To Next Page
Loading...